User's Manual
Table Of Contents
- Introduction
- Abbreviation
- Features
- Electrical Specifications
- Host interface pin assignments
- LGA Pad Diagram
- Pin Assignments
- Power supply
- USB interface
- SGMII interface
- UIM interface
- Control interface
- Power-on Signal
- Wake-up interface
- Reset Signal
- WWAN state Signal
- Digital interface
- JTAG Interface
- SPI Master Interface
- PCM Interface
- I2S Interface
- I2C Interface
- UART Interface
- ADC Interface
- RF Specifications
- RF connections
- Interference and sensitivity
- GNSS external circuit design
- RF Specification
- 3.5.1 Band support
- 3.5.2 Bandwidth support
- 3.5.3 RF Transmit Specification
- 3.5.4 RF Receiver Specification
- 3.5.5 GNSS Receiver Specification
- Power
- Power consumption
- Software Interface
- Support tools
- USB interface
- Mechanical and Environmental Certifications
- PCBA Form Factor
- Reflow
- PCB pad design
- Labeling
- SMT Voids control
- Mother board PCB thickness
- Stencil design
- Thermal considerations
- Regulatory Compliance and Certification
- Certification testing
- Packaging
- Tape-and-Reel Package
- Single Packaging for Samples
- MSL level
- Safety Recommendation
54
/
71
HW Design Guidelines
It is not recommended to place via or micro-via not covered by solder resist in an area of
0.3 mm around the pads unless it carries the same signal of the pad itself, see following
figure.
Holes in pad are allowed only for blind holes and not for through holes.
6.4. Labeling
Figure26 shows label drawing of M18QF/M18QA Series modules.