User's Manual
Table Of Contents
- Introduction
- Abbreviation
- Features
- Electrical Specifications
- Host interface pin assignments
- LGA Pad Diagram
- Pin Assignments
- Power supply
- USB interface
- SGMII interface
- UIM interface
- Control interface
- Power-on Signal
- Wake-up interface
- Reset Signal
- WWAN state Signal
- Digital interface
- JTAG Interface
- SPI Master Interface
- PCM Interface
- I2S Interface
- I2C Interface
- UART Interface
- ADC Interface
- RF Specifications
- RF connections
- Interference and sensitivity
- GNSS external circuit design
- RF Specification
- 3.5.1 Band support
- 3.5.2 Bandwidth support
- 3.5.3 RF Transmit Specification
- 3.5.4 RF Receiver Specification
- 3.5.5 GNSS Receiver Specification
- Power
- Power consumption
- Software Interface
- Support tools
- USB interface
- Mechanical and Environmental Certifications
- PCBA Form Factor
- Reflow
- PCB pad design
- Labeling
- SMT Voids control
- Mother board PCB thickness
- Stencil design
- Thermal considerations
- Regulatory Compliance and Certification
- Certification testing
- Packaging
- Tape-and-Reel Package
- Single Packaging for Samples
- MSL level
- Safety Recommendation
63
/
71
HW Design Guidelines
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.