User's Manual

This is a client product and do not have rador detection function specified by FCC.

The software will not let you to use ad-hoc under 802.11a.

 Ad Hoc Net Start: Specifies a band to establish an Ad Hoc network if no matching

SSID is found. Options available are the following: 802.11b and 802.11g.

NOTE! Ad-hoc mode is available only for 802.11b/g. It is not available for 802.11a.

This is a client product and do not have radar detection function specified by FCC.

The software will not let you to use ad-hoc under 802.11a.

 802.11b Range: Options are Normal Range and Extended Range. This function can

let user to determine the transfer range in 802.11b mode. Extended Range can prolong

the transfer range with a lower data transmitting rate.

 Scan Mode: Options are Active Scan, Passive Scan and Auto. In Active Scan, the

driver sends out the probe request frames from each channel and collects the response

frames from the responding. In Passive Scan, the driver scan each requested channel,

listening the beacons on each channel.

 Transmit Power: This setting allows you to change the output power of the PC Card to

increase or decrease the coverage area.

 QoS: Disables or enables the PC Card to cooperate in a network using QoS

(Quality of Service).

 2.4 GHz Preamble: Allows Ad-Hoc compatibility with other 2.4 GHz devices. Two

options are Short and Long and Long only. Use Long Only when configuring the

client for an 802.11b RoamAbout AP wireless network.