User's Manual

To OEM installer:
1a. FCC ID label on the final system must be labeled with "Contains FCC ID:
NKR-SWA6" or "Contains transmitter module FCC ID: NKR-SWA6".
1b. IC Canada label on the final system must be labeled with “Contains
Module WNC SWA6 IC: 4441A-SWA6”
2.In the user manual, final system integrator must be ensured that there is no
instruction provided in the user manual to install or remove the transmitter
module.
3. Transmitter module must be installed and used in strict accordance with the
manufacturer is instructions as described in the user documentation that
comes with the product. This device complies with the following radio
frequency and safety standards.
4. To inherit the modular approval, the antennas for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna
or transmitter.
The user manual of the final host system must contain the following
statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device
and its antenna must not be co-located or operating to conjunction with any
other antenna or transmitter.