User's Manual

Wistron
NeWeb
®
Wistron NeWeb Corporation
20 Park Avenue II, Hsinchu Science Park, Hsinchu 308, Taiwan, R.O.C.
Phone: [phone] Fax: [phone]
Website: www.wneweb.com
Wistron NeWeb Confidential Document
9
6.2. DC Electrical Characteristics
Operating Conditions: +5V_IN = 5.0V ±10%, T
A
=0ºC to +50 ºC; RF Chan. Freq. = 2412MHz to 2462MHz. All
specifications are referenced to the AVMD7540-SWA6 edge connector pins and RF connectors, unless
otherwise specified. Typical specifications at 5.0V and 25 ºC.
Table 6-2 6 -3 AVMD7540-SWA6 DC Electrical Characteristics
PARAMETER CONDITIONS MIN TYP MAX UNIT
Input supply voltage Driven by an external regulator 4.5 5.5 V
Supply Current – (Note 1) RESET 10 mA
RX mode: 1 stereo output I2S 100 mA
CMOS I/O Logic Levels – 3.3V I/O
Input Voltage Logic Low, V
IL
Internal regulator = 3.3V 0.6 V
Input Voltage Logic High, V
IH
Internal regulator = 3.3V 2.0 V
Output Voltage Logic Low, V
OL
Internal regulator = 3.3V; I
LOAD
=1mA 0.4 V
Output Voltage Logic High, V
OH
Internal regulator = 3.3V; I
LOAD
=1mA 2.9 V
Note 1: The operating states are defined as:
RESET = AVMD7540-SWA6 is held in reset by holding SM0 low
RX mode: AVMD7540-SWA6 is operating in a link as a client node receiving 1 stereo channel of 16bit,
48kHz audio.
6.3. Electrical Characteristics – RF Receiver
Operating Conditions: +5V_IN = 5.0V ±10%, T
A
=0ºC to +50 ºC; RF Chan. Freq. = 2412MHz to 2462MHz. All
specifications are referenced to the AVMD7540-SWA6 edge connector pins and RF connectors, unless
otherwise specified. Typical specifications at 5.0V and 25 ºC.
Table 6-3 -4 AVMD7540-SWA6 Electrical Characteristics – RF Receiver
PARAMETER CONDITIONS MIN TYP MAX UNIT
RF Channel Frequency Range 2412 2462 MHz
Sensitivity (Note 1) T
A
=25ºC -80 dBm
Max Input Signal (Note 1) -5 dBm
Spurious RF outputs
2400-2483.5 MHz
<2400 MHz
>2483.5 MHz
-47
-60
-60
dBm
dBm
dBm
LO leakage -47 dBm
Note 1: Sensitivity and max signal level are defined as the onset of 1% BLER Block Error Rate.