24GHz Blind Spot Detection Radar User Manual V0.
Content Blind Spot Detection Radar System ...................................................... 1 Notice: ................................................................................................. 1 Radar and Warning System location .................................................... 1 Warning level ....................................................................................... 3 Detection range and warning systems..................................................
1 24GHz Blind Spot Detection Radar Blind Spot Detection Radar System 24GHz radar blind spot detection system (hereinafter referred to as BSD system) is a set of auxiliary system which uses radar sensor to detect road traffic conditions and visual blind spot area. It is to provide alert information for driver when changing lanes. This blind spot monitoring system set range includes both sides and the rear of the vehicle.
2 24GHz Blind Spot Detection Radar Radar sensors are installed in the rear bumper of the left and right sides (such as schematic in Figure 1). The radars on the two sides help drivers detect vehicles. (Figure 1) If the radar sensor is obscured, it may not detect obstacles and reduce system performance. To avoid radar sensor function is affected, please pay special attention to the following points: Do not shield radar sensor foreign body parts (such as stickers, bike rack, trailer).
3 24GHz Blind Spot Detection Radar Blind spot detection system startup and shutdown Start up After pressing the button, the button's indicator light is and the system is turned on. Shut down Pressing the button again, the indicator on the button goes off button and the system is shut down. When you turn off the system, you will not receive alerts. Blind spot detection system switch will remain in the position you set.
4 24GHz Blind Spot Detection Radar Level One and Level Two warning is to remind the driving situation. Driver still needs to concentrate and observe the driving conditions. Detection range and warning systems When you start the engine / ACC (TBD), the blind spot detection system indicator will appear briefly lit and warning beep sound to confirm that the system is functioning properly. For automatic transaxle car, this system only works when the S, D gear.
5 24GHz Blind Spot Detection Radar consider driver is driving whether in the center of the lane or in the edge of the lane. If the driver rides in the narrow lane or does not in the center of the road, the system may not provide alert for the vehicle driving in adjacent lane (as shown in Figure B) based on Level One and Two Warning. When driving on a relatively wide lane, the blind spot detection system may not detect the vehicle on the adjacent lane because they are out of the observation range.
6 24GHz Blind Spot Detection Radar Please note that the design of the blind spot detection system is not used to avoid collisions with other vehicles or objects. blind spot detection system cannot be sole basis for for hanging lanes. Please keep driving carefully. This system provides a warning only as a assistant tool to help you to find the vehicle in blind spot area. Radar detection limitation In some cases, when the vehicle enters or leaves the blind area it may cause improper detection.
7 24GHz Blind Spot Detection Radar False alarms In some cases, an warning occurs but there is no vehicles in the blind spot area. In this case, the alarm is usually a temporary error and the system will correct itself.
8 24GHz Blind Spot Detection Radar Blind spot zone and the radar viewing area Blind Spot Zone(Alert Area) Radar Viewing Area - Wistron NeWeb Corp.
9 24GHz Blind Spot Detection Radar FCC Statement: FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
