CA10002 User’s Manual This document provides instructions for installing the antenna and describes the requirements and specifications of this product. The antenna can be mounted on a vertical or horizontal surface, or on a slope. Read this document carefully before installing to ensure your safety and product performance.
Contents FEDERAL COMMUNICATION COMMISSION (FCC) INTERFERENCE STATEMENT ............ 3 BEFORE YOU START .................................................................................................... 3 IMPORTANT SAFETY INSTRUCTIONS .......................................................................... 3 UNPACKING INFORMATION ........................................................................................ 5 WIRING PLAN ..........................................................................
Federal Communication Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Warning: For your safety, follow these important safety precautions: 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this unit near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Unpacking Information Thank you for purchasing this product. Before installation, please confirm you have collected all required items: Note: Not all accessories are included inside one the same carton. Consult your dealer if any of them are missing.
Wiring Plan Basic connection: In this example, the Cantanna connects directly to the power inserter and then to the Home Service Gateway without connecting home coaxial network. Selecting an Installation Location The product is designed to be installed vertically on a flat surface. The surface can be horizontal, vertical or a slope. See following notes before choosing an installation location: Note: Ensure that there is enough space for adjusting the antenna angles.
Installing the Cantenna 1. With the protection pulp, take the product out of the box. Place the product upside down on a flat surface 2. Install the mounting plate with the product using the 4 screws in screw pack 1 (5/16” 18UNCx15mm.) Fully tighten the four screws. 3. Install the pedestal to the location you selected using the screws in screw pack 2.
4. Tighten the grounding screw and securely ground the wire. 5. Adjust the angle of the pedestal mast. Use the spirit level and confirm the bubble is perfectly located at the center position. Fully tighten the mast screws after confirming the mast angle. Note: You may also need to fine-tune the height of the pedestal screws that you installed in step3 for obtaining a perfectly horizontal position. 6. Grip the mounting plate and take the product to the installation location.
7. Attach the Cantenna to the pedestal and remove the protection pulp. Tighten the 2 bolts on the mounting plate. 8. Connect one end of a coax cable to the Power port of the Cantenna. Run the cable from the Cantenna to the power inserter and attach the cable to the “POWER TO ODU” port of the power inserter. Note: This step demonstrates the basic connection method.
. Plug the power inserter to a wall power socket. 11. Connect your Ethernet compatible devices to the home service gateway for accessing the Internet.
LED Indicators LQI Red: Low LTE signal strength Blue: Medium LTE signal stregth Green: High LTE signal strength Coax Network Red: Power supply connected Green: Valid connection to Home service gateway. Product Specifications Items Description Power Input DC 15~20.5V, 1.
