User's Manual
Table Of Contents
- Table of Contents
- Magellan Maestro 4200
- Installation Instructions
- Fundamentals
- Map Screen
- Home Address
- Enter Address
- Entering an Address
- My Addresses
- Accessing the My Addresses Menu
- Routing to a Previous Destination (Method 1)
- Routing to a Previous Destination (Method 2)
- Saving a Previous Destination to Your Address Book
- Deleting a Previous Destination
- Accessing an Address in Your Address Book
- Routing to an Address in Your Address Book
- Editing an Address in Your Address Book.
- Deleting an Address in Your Address Book.
- Accessing an Address from Favorites
- Routing to an Address from Your Favorites List
- Editing an Address from Your Favorites List
- Deleting an Address from Your Favorites List
- Creating a New Entry to You Address Book by Selecting on the Map
- Creating a New Entry to You Address Book by Entering an Address
- Creating a New Entry to You Address Book from a POI
- Creating a New Entry to You Address Book from by Intersections
- Intersection
- Points of Interest (POI)
- Travelling on a Route
- Trip Planner
- Exit POIs
- User Options
- Selecting Map Region
- Accessing System Settings
- Checking Battery Life
- Adjusting the Volume
- Adjusting the Display Brightness
- Setting Auto Power Off Time
- Setting Time Zone
- Selecting Units of Measure
- Displaying Contact Us Information
- Displaying Product Information
- Performing Diagnostics
- Accessing the Trip Computer
- Selecting POIs to be Displayed on the Map
- Deleting Addresses from the Address Book (Global)
- Setting the Map in 3D or 2D Mode
- Setting the Map Display to Heading Up or North Up
- Setting Split Screen (TrueView™) Options
- Setting Auto Night Map Display
- Setting Detour Options
- Using the Simulator
- Setting Tone Options
- Viewing Technical GPS Information
- Setting the GPS Position
- Backing Up and Restoring Data
- Backing Up Data
- Restoring Data
- Viewing Map Information
User Options 50
Tap Stop to end simulating the current route you are simulating.
(The Simulate button is presently not active.)
4. Tap Back arrow to record the changes and exit.
Setting Tone Options
Provides a way of selecting the tone used to announce arrival at a maneuver or destination.
1. From page 2 of the Main Menu, tap User Options.
2. Tap Tone Options.
3. Select Bell, Chime or Beep.
4. Tap Save to record the changes and exit.
Viewing Technical GPS Information
This screen provides technical information about the satellites being used to compute the GPS
position.
1. From page 2 of the Main Menu, tap User Options.
2. Tap GPS Options.
3. Tap GPS Status.
PRN: pseudo random number that identifies
the satellite
AZ: Azimuth of the satellite
EL: Satellite elevation
SNR: Satellite signal-to-noise ratio
TTFF: Time to First Fix (in seconds)
4. Tap Back arrow to exit.
Setting the GPS Position
Setting a GPS position is useful if you are not getting satellite information quickly because the
Magellan Maestro has travelled over 500 miles while turned off. Setting the GPS position will allow
the Magellan Maestro to compute which satellites are available and calculate the position quicker.
1. From page 2 of the Main Menu, tap User Options.
2. Tap GPS Options.
3. Tap Set GPS Position.
4. Follow the prompts to enter the address where you currently are.
5. Tap Done when finished entering the address.