User's Manual
Table Of Contents
- Table of contents
- 1 Introduction
- 2 Before you begin
- 3 Switching on the NAVIGON 72XX
- 4 Password Lock
- 5 Operating the NAVIGON 72XX
- 6 Navigation
- 6.1 Starting the navigation application
- 6.2 Specifying a destination
- 6.2.1 Specifying the country in which the destination is situated
- 6.2.2 Entering an address
- 6.2.3 Selecting the destination address by voice command
- 6.2.4 Points of interest
- 6.2.5 Information about the destination
- 6.2.6 Last Destinations
- 6.2.7 Favourites
- 6.2.8 Imported addresses
- 6.2.9 Navigating home
- 6.2.10 Selecting destinations on the map
- 6.2.11 Starting navigation
- 6.3 Managing destinations
- 6.4 Multi-leg routes
- 6.5 Options
- 6.6 Working with the map
- 6.7 Useful functions
- 7 Handsfree Module
- 8 Configuring the NAVIGON 72XX
- 9 Appendix
- 10 Troubleshooting
- 11 Index
User's manual NAVIGON 72XX
- 38 - Navigation
New Route: Deletes the starting point and all route points from the ROUTE
PLANNING window so that you can plan a new route.
If necessary, save the previously planned route!
Password Lock
: Opens a window to configure the password protection. (Refer
to "
Password Lock" on page 15)
Product Information
: Here you are shown the version numbers and copyright
details of the hardware and software.
Rename
: Opens a window in which you can change the name for the selected
destination or route.
Route Planning
: Opens the ROUTE PLANNING window. Here you can plan
routes, manage planned routes and start navigation on a planned route.
(Refer to "
Multi-leg routes" on page 33)
Route Profile
: Opens the ROUTE PROFILE window. Here you can view the
options for route planning and, if necessary, change them.
Save as Favourite
: Saves the selected destination to the FAVOURITES list. (Refer
to "
Saving destinations" on page 32)
Save Destination
: Saves the selected address in the FAVOURITES list. (Refer to
"
Saving destinations" on page 32)
Save Route
: Opens a window in which you can save the planned route under a
specific name. (Refer to "
Saving routes" on page 35)
Saved Routes
: Opens a dialog window into which you can load a saved route.
Settings
: Opens the SETTINGS window. Here you can configure the navigation
system. (Refer to "
Configuring the NAVIGON 72XX" on page 51)
Show on Map
: Shows the selected address on the map.
Simulation
: Simulates a navigation on the route indicated. This simulation can
be performed without GPS reception. On multi-leg routes, only the first
leg is simulated.
Touchscreen Calibration
: The touch screen can be re-calibrated if it responds
poorly to touch. Follow the instructions on the screen.
Traffic
: Opens the TRAFFIC INFORMATION window in which pending reports are
listed. (Refer to "
TMC (Traffic Information)" on page 49)
Turn-by-Turn List
: Shows detailed directions for the route, including all points at
which you must turn. (Refer to "
Turn-by-Turn List" on page 48)