User Manual Part 5

5 Software78
.
Parameter Description
Serial Port B Enables or disables the infrared port.
Options: Enabled or Disabled
Base I/O Address Sets the I/O address of the infrared port.
Options: 3F8h, 2F8h, 3E8h or 2E8h
Interrupt Sets the IRQ request of the infrared port.
Options: IRQ 4, IRQ 3
DMA channel Sets the direct memory access of the infrared port.
Options: DMA 1 or DMA 3
Parallel Port Enables or disables the parallel port.
Options: Enabled or Disabled
Mode Sets operation mode of the parallel port.
Options: Output only, Bi-direction, EPP, or ECP
Base I/O Address Sets the I/O address of the parallel port.
Options: 3BC, 378h, or 278h
Interrupt Sets the interrupt request of the parallel port.
Options: IRQ 5 or IRQ 7
ECP DMA
Channel
Sets a DMA channel for the printer to operate in ECP mode. This
parameter is enabled only if Mode is set to ECP.
Options: DMA 1 or DMA 3
AJ-e.book Page 78 Friday, April 11, 2003 5:18 PM