User Manual Part 5

5 Software80
The table below describes the parameters in this screen. Settings in boldface are
the default and suggested parameter settings.
Note: Don’t forget your password. If you forget your password, you
may have to return your notebook computer to your dealer to reset it.
Setting a password
Follow these steps:
1. Use the
↑ and ↓ keys to highlight a password parameter (Setup, Power-on, or
Hard Disk) and press the Enter key. The password box appears:
2. Type a password. The password may consist of up to eight alphanumeric
characters (A-Z, a-z, 0-9).
Important: Be very careful when typing your password because the
characters do not appear on the screen.
Parameter Description
Setup Supervisor
Password
When set, this password protects the BIOS Utility from
unauthorized entry.
Press Enter to set this password.
Set User Password When set, this password protects the computer from
unauthorized entry during boot-up or resume from Hibernation
mode.
Press Enter to set this password.
Password on Boot When enabled, a password is requested when the system boots
up.
Options: Enabled or Disabled
Set Primary Hard
Disk Password
When set, this password prevents the primary hard disk from
unauthorized access. It consists of 8 alphanumeric characters.
Press Enter to set this password.
Set Secondary Hard
Disk Password
When set, this password prevents the secondary hard disk from
unauthorized access. It consists of 8 alphanumeric characters.
Press Enter to set this password.
AJ-e.book Page 80 Friday, April 11, 2003 5:18 PM