User Manual Part 5

87
charged?
To preserve the life of the battery, the system only lets you charge the battery when
its capacity falls below 95%. However, it is recommended that you bring an extra
battery and let the battery in the system use up its power before charging it.
Error messages
If you receive an error message, note the message and take the corrective action.
The following table lists the error messages in alphabetical order together with the
recommended course of action.
Error Messages Corrective Action
CMOS Battery Bad Contact your dealer or an authorized service center.
CMOS Checksum Error Contact your dealer or an authorized service center.
Disk Boot Failure Insert a system (bootable) diskette in the floppy drive
(A:), then press Enter to reboot.
Equipment Configuration
Error
Press F2 (during POST) to enter the Setup Utility; then
press Esc to exit and reconfigure the computer.
Hard Disk 0 Error Contact your dealer or an authorized service center.
Hard Disk 0 Extended Type
Error
Contact your dealer or an authorized service center.
I/O Parity Error Contact your dealer or an authorized service center.
Keyboard Error or No
Keyboard Connected
Contact your dealer or an authorized service center.
Keyboard Interface Error Contact your dealer or an authorized service center.
Memory Size Mismatch Press F2 (during POST) to enter the Setup Utility; then
press Esc to exit and reconfigure the computer.
Missing operating system Follow these steps:
1. Press F2 (during POST) to enter the Setup Utility.
2. Exit the Setup Utility (saving the changes).
Non-system disk or disk
error. Replace and strike
any key when ready
Insert a system (bootable) diskette in the floppy drive
(A:), then press Enter to reboot.
AJ-e.book Page 87 Friday, April 11, 2003 5:18 PM