User Manual

Ambit Microsystems Corporation國碁電子(股)公司
5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.
TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\
中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之1
電話886-3-5784975，傳真：886-3-5782924
Section Four: FCC Notice
4.1 FCC Compliance
This Equipment complies with Part 68 of the FCC Rules. On this equipment is a label that contains, among other information,
the FCC registration number and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide
this information to your telephone company.
If your telephone equipment causes harm to the telephone network, the Telephone Company may discontinue your service
temporarily. If posible, they will be notify in advience. But if advance notice isn’ t practical, you will notified as soon as
possible. You will be informed of your right to file a complaint with the FCC.
Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect proper
operation of your equipment. If they do, you will be notified in advance to give you an opportunity you maintain
uninterrupted telephone service.
The FCC prohibits this equipment’ s should fail to operate properly, disconnect the equipment from the phone line to
determine if it is causing the problem. If the problem is with the equipment, discontinue use and contact your dealer or
vendor.
4.2 FCC Class B Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on , the user is encouraged to try to correct the interference by one or more of the following measures:
l Reorient or relocate the receiving antenna
l increase the separation between the equipment and the receiver
l Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
l Consult the dealer or an experienced radio/TV technician for help
Notice: (1)Shielded cables, if any, must be used in order to comply with the emission limits. (2) Any change or
modification not expressly approved by the grantee of the equipment authorized could void the user authority to operate the
equipment.
Caution: Please make sure you already disconnect the phone cable before you want to touch or remove modem module.








