User Manual

To enable 64-bit (40-bit) or 128-bit encryption with authentication:

1. Select the wireless adapter in the left-side pane.

2. From the General page, click the Networks tab.

3. Select the profile from the Profile List and click the Edit button or click the Add button if you are

using the Profile Wizard.

4. Click the Security tab. Select Security Settings, the third dialog if using the Profile Wizard.

5. Select Shared from the Network Authentication drop-down box.

6. Select 64-bit or 128-bit from the Encryption Level drop-down box.

7. Select a key index number 1, 2, 3, or 4 from the Encrypt data with key index drop-down box to use

for encryption. Key selection corresponds to the WEP encryption pass phrase or WEP key.

8. Select either of the following:

● Pass phrase: Click Use Pass Phrase to enable it. Enter a text phrase, up to

five (using 64-bit) or 13 (using 128-bit) alphanumeric characters (0-9, a-z or

A-Z), in the pass phrase field.

● WEP key: Click Use WEP Keys to enable it. Enter up to ten (using 64-bit)

alphanumeric characters, 0-9, A-F, or twenty-six (using 128-bit)

alphanumeric characters, 0-9, A-F in the WEP key field.

9. Click OK if editing a profile or Finish if in the Profile Wizard to save the settings.

NOTE: You must use the same encryption type, index number, and WEP key as other devices on

your wireless network.

Back to Contents Page