User Manual

2
1 F ir st Thi ngs Fir st
Preparing to use your SP510
To install the battery pack:
Align the tabs on the battery pack with the grooves on the rear side of the device, and then
insert the battery pack in place. The battery pack locks to the chassis with an audible click.
To uninstall the battery pack:
1 If the device is on, press the Power button to turn off the device.
Wait for five seconds to allow the device to completely power off.
2 Slide the battery latch toward the unlock icon to release the battery pack from the
chassis (1).
3 Completely detach the battery pack from the device (2).
Charging the SP510
Initial charging of a standard life battery takes about four hours. The extended life battery type
requires at least eight hours. After the initial charging, charge your device everyday to restore
the battery to full capacity. Charge your device using the AC adapter cable, see instructions
below.
While waiting for the initial charging to complete, install Microsoft
®
ActiveSync
®
4.2 or higher on
your computer to prepare for the initial synchronization procedure. Refer to the next section for
instructions.
To charge your device:
NOTE: Use the clip plug applicable in your country.
1 Slide the replaceable clip plug into the AC adapter until it locks into place with an audible
click.
2 Plug the AC adapter cable into the mini USB connector on bottom of the device.
3 Connect the AC adapter cable into an electrical outlet.
The LED indicator on the right side of the touch screen lights up orange to signify
that AC connection is made.
If the battery level becomes low in the course of normal use, a status icon appears
on the device screen indicating low or depleted battery status (see "Status icons" on
page 18 for more information). In both cases, perform an ActiveSync operation to