User's Manual

Table Of Contents

MTK952 User Manual

rev.06

Synchronization

The SYNC function is useful to tune a transmitter on the same frequency of the receiver via the IR

interface.

 Enable the IRDA on the receiver and place the IR windows of the receiver in front of the

IR interface of the transmitter as indicate in the below image.

 Press the SYNC button on the transmitter: the following message is showed on

both the displays

 Using the membrane buttons of the desired transmitter (TX1 or TX2) select:

 TX->RX to set the receiver at the same frequency of the transmitter:

the transmitter will send to the receiver some parameters (frequency, channel,

group and transmitter’s name) and after synchronization, the receiver shows the

name of the transmitter

 RX->TX to set the transmitter at the same frequency of the receiver:

the receiver will send to the transmitter some parameters (frequency, channel,

group and receiver’s name) and after synchronization, the transmitter shows the

name of the receiver (ex. SINGER_1)

If the operation is not possible, (i.e. the frequency range of the transmitter is not compatible with

the frequency of the receiver or vice versa), the display shows an error message.

If the synchronization is successful, the display of the devices shows number of channel and group

or SYNC channel according to the frequency plan memorized on the Wisycom product:

RX->TX

TX->RX