Owner's manual

HMD SERIES F-41142 (10-09)
3
GENERAL
INTRODUCTION
Wittco HumidiHeat™ Holding &
Transport Cabinets are produced with
quality workmanship and material.
Proper installation, usage, and
maintenance of your cabinet will result
in many years of satisfactory
performance.
It is suggested that you thoroughly read
this entire manual and carefully follow all
of the instructions provided.
The HMD Series Holding & Transport
Cabinets provide an efficient means of
transporting and holding bulk prepared
foods at proper serving temperatures.
INSTALLATION
Before installing, verify that the electrical
service agrees with the specifications on
the rating plate located on the lower
back corner of the cabinet. If the supply
and equipment requirements do not
agree, do not proceed with unpacking
and installation. Contact your Wittco
Customer Service Department
immediately. (Fig. 1)
(Fig. 1)
UNPACKING:
The Cabinet was inspected before
leaving the factory. The transportation
company assumes full responsibility for
safe delivery upon acceptance of the
shipment. Immediately after unpacking,
check for possible shipping damage to
the cabinet.
If the cabinet is found to be damaged,
save the packaging material and
contact the carrier within 15 days of
delivery.
Carefully unpack and place in a work
accessible area as near the installation
position as possible.
1. Open the door and carefully
remove any packaging materials
and the retaining straps that hold
the tray slides and tray slide
upright side supports.
2. Peel off vinyl protection film.
3. Remove cardboard element
cover protector from cabinet
bottom.
4. Remove adjustable tray slides
from box.
5. Remove the tray slide supports
and install them in the cabinet.
6. Hook the openings in the flat
flange of the support over two
vertical carriage bolts on the
interior of the cabinet.
7. Make sure all flanges on the four
supports face the door opening.