NA DRAWER WARMER F-41215 (02-14)
4
ELECTRICAL REQUIREMENTS
ELECTRICAL CODES & STANDARDS:
The warmer must be installed in
accordance with:
In the United States of America:
1. State and Local Codes.
2. National Electrical Code, ANSI/
NFPA-70 (latest edition.) Copies
may be obtained from: The
National Fire Protection
Association, Batterymarch Park,
Quincy, MA 02269.
In Canada:
1. Local Codes.
2. Canadian Electrical Code, CSA
C22.1 (latest edition.) Copies
may be obtained from: The
Canadian Standard Association,
178 Rexcale Blvd., Etobicoke,
Ontario, Canada M9W 1R3.
In United Kingdom:
1. Local codes.
ELECTRICAL CONNECTIONS:
The warmer is factory wired for
220–240 V, single phase operation.
Refer to wiring diagram in the back of
this manual.
Verify that the power source matches
the Serial Data Plate located on the
lower back corner of the warmer and
the plug configuration before the
connection is made.
(Fig. 1)
SERIAL DATA PLATE
Fig. 1