User manual

WT-1041 3G Camera

WT-1041 – User Manual – Rev.1.2 - Technical Support: technical@witura.com

1) Insert a 3G SIM Card into the WT-1041 3G Camera

2) Connect to charger

3) Finding the network signal

>> Switch on the 3G cam

>> Firstly battery indicator lights red (2 sec per time) & network indicator lights

green (flash quickly 0.5 sec per time)

>> After find the network signal, green lights flash at 2 sec per time

4) Setting host number

Note : For first time use of 3G Camera, you must set your phone number as HOST

Number via message

: Host number can do any operation such as video call, password setting

: Original password is 888888

>> BATTERY INDICATOR: RED

a) Red Flash Quickly : Power Is Low

b) Flash Per 2 sec : Normal / Finish Charging

>> NETWORK INDICATOR: GREEN

a) Flash Per 2 sec : Normal

b) Flash quickly : No SIM Card/ SIM Card not insert properly

Note: Do not pull the SIM Card out when the charger is connected

When products is powered on, it can detect charger is inserted. At this

time Battery indicator is RED

Note: Before installing the SIM Card make sure that the power switch is set off.

4. GETTING STARTED

Host Number Setting