WT-2232 3 32 2C Ch ha an nn ne ell G GS SM MV VO OIIP PG Ga atte ew wa ay y User Manual
WT-2232 32 Channel GSM VOIP Gateway Introduction WT-2232 32 channels GSM VOIP Gateway for call termination (VoIP to GSM and GSM to VoIP). It is SIP based and compatible with Asterisk. It can enable to make 16 Calles simultaneously from IP phone to GSM network and GSM network to IP phone. Main Features · Support H.323, SIP (RFC3261) compliance · Network frequency: Quad band 850/900/1800/1900Mhz · Codec:G.711u-Law ,G.711a-Law,G.723(5.3k),G.723(6.3k),G.
WT-2232 32 Channel GSM VOIP Gateway 2.1. WT-2232 GSM VOIP Gateway package list: 2.1.1 VoIP GSM Gateway (mainframe) 2.1.2 Antenna (FME): WT-2232:32pcs or 2pcs high gain antenna (or Yagi antenna) 2.1.3 Power Line: 1pcs 2.1.4 Network Cable: 1pcs 2.1.5 Data cable: 1pcs 2.1.6 Telephone cable (RJ-11): 1pcs 2.1.7 Accessories (GSM Divider and N-SMA cable) 2.1.1 WT-2232 Dimension 2.1.2 High Gain Antenna 2.1.3 Power Line WT-2232 – USER MANUAL – Rev1.0 – Technical Support: technical@witura.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway 2.1.4 Network Cable After completing to set up all the parameters, click “Save” in the system tool and press the “Reset”, and then system will be reboot. 2.1.5 Data Cable 4.2.14 IAD Status For check and monitor working status, please show as following: 2.1.6 Telephone Cable 2.2 Chart Of the Device WT-2232 – USER MANUAL – Rev1.0 – Technical Support: technical@witura.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway 4.2.11 Remote Management 2.2.1 Power indicator: Light up when SIP power is normal. 2.2.2 10M/100M: an link indicator light of LAN 2.2.3 10M/100M: a link indicator light of WAN 2.2.4 WAN: RJ-45 internet socket, connect to router or HUB, use for communication 2.2.5 LAN: RJ-45 internet socket, connect to network card of PC, use for configuration. 2.2.6 RS232: use for programming and debug 2.2.7 Antenna connector 2.2.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway 2.4 4.2.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway (i) Pull out the drawer type of SIM slot at the back of the unit (ii)Take the SIM at the SIM slot (iii) Push the SIM drawer into the unit * For takeout the SIM, please press the SIM switch until SIM slot out (4) (5) Input the antenna into the socket. Plug the end of the conjunction line of the phone (payphone) into the RJ11 socket of the Gateway and connect the other end to the phone(payphone).
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway (2). Point to Point (without SIP account) 4.2.7 Phone Setting Phone Configuration (Instance of SIP Protocol Registration) Using SIP platform, there’re generally four parameters allotted to users: phone number, a/c, password and SIP server address. Specifically, it needs to set up 3.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway B C D E software version Speaker Volume MIC Volume Block Incoming call CLIR (Call identication restriction) Incoming Caller ID display PDD Dialing Setting Reset to Factory Setting **30*XX# (X=00-99) **31*X# (X=00-15) ***97*X# X=1 Block, X=0 Allow ***95*X# X=1 Caller ID Hide, X=0 Send Caller ID ***96(X# X=1 hiding incoming number, X=0 display ***82*X# X=2~9, send Calling time (second) ***### 3.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway Page Setting IP Mask: For filling IP mask for LAN port 4.1 Users Access Internet through LAN or Cell Wideband 4.1.1 Use phone line to connect the port interface of gateway with common analog phone. 4.1.2 Use the Ethernet cable attached with the machine randomly to connect the WAN interface of gateway with the RJ45 interface of switcher. 4.1.
WT-2232 32 Channel GSM VOIP Gateway WT-2232 32 Channel GSM VOIP Gateway ☆ Setup of Computer The factory default value of IP address of gateway is: LAN Interface: 192.167.1.1, Subnet Mask: 255.255.255.0. WAN Interface: 192.168.1.67, Subnet Mask: 255.255.255.0.
WT-2232 32 Channel GSM VOIP Gateway (2) WT-2232 32 Channel GSM VOIP Gateway Type user name “root” and password “root” to enter into the configuration interface of VoIP voice gateway as follows: 4.2.3 Language Currently VoIP GSM gateway supports English, Simplified Chinese. Select the language desired and the Web page will be shown in the language selected accordingly. 4.2.5.1 Network Setting\WAN Setting 1. STATIC(static IP): IP address is assigned & fixed, which is generally used by WAN.