User manual

10
WT-2232 32 Channel GSM VOIP Gateway
WT-2232 – USER MANUAL – Rev1.0 – Technical Support: [e-mail]
COPYRIGHT ©2011 WITURA CORPORATION SDN BHD
4.1 Users Access Internet through LAN or Cell Wideband
4.1.1 Use phone line to connect the port interface of gateway with common
analog phone.
4.1.2 Use the Ethernet cable attached with the machine randomly to connect
the WAN interface of gateway with the RJ45 interface of switcher.
4.1.3 Use an Ethernet cable to connect LAN interface with the RJ45 interface of
switcher, and the LAN interface under this network environment can only
be used for gateway billing and setting and can’t be used for Internet surf.
4.1.4 After connecting power supply, turn on the switch. After power supply is
turned on, confirm one of 10/100M light of WAN interface of gateway is
on.
4.2 Setup of Software
4.2.1 Preparation before Software Setup
Please confirm the following information before setup. Any questions
please contract with related service suppliers.
The information set up according to different environment requirement is
as Table 2.1:
Network Access
Environment
ADSL LAN
Necessary Information 1. User Name’
2. Password
1. Acquisition way
for IP Address
(Automatic
Acquisition or
assigned IP)
2. IP address and
subnet mask
assigned to
gateway
3. Default
gateway for
internet surf
Page Setting
15
WT-2232 32 Channel GSM VOIP Gateway
WT-2232 – USER MANUAL – Rev1.0 – Technical Support: [e-mail]
COPYRIGHT ©2011 WITURA CORPORATION SDN BHD
IP Mask: For filling IP mask for LAN port
2. DHCP
If you want select DHCP mode, please enable the DHCP server to on and filling
“Start IP”, “End IP”, “IP Mask”, “Gateway IP”, “DNS Server”, the DHCP setup as
following:
4.2.5.3 Network Setting\Network Work Mode Setting
Its setup working mode of WAN and LAN, please check as following:
4.2.6 Protocol Setting