User manual

WT-2232 32 Channel GSM VOIP Gateway

WT-2232 – USER MANUAL – Rev1.0 – Technical Support: technical@witura.com

Users can obtain the IP address to Internet surf without setting up any

parameters when choosing DHCP.

3. PPPoE :

PPPoE is a common dial up method for you network modem (Cable / xDSLs).

Choose this if your network environment requires. Enter the User Name and

Password as provided by your ISP.

4.2.5.2 Network Setting\LAN Setting

The LAN Port modes are supported: DHCP, Static IP.

1. Static Mode:

IP Address: For filling fixed IP Address for LAN port

WT-2232 32 Channel GSM VOIP Gateway

WT-2232 – USER MANUAL –

Rev1.0

–

Technical Support: technical@witura.com

☆ Setup of Computer

The factory default value of IP address of gateway is:

LAN Interface: 192.167.1.1, Subnet Mask: 255.255.255.0.

WAN Interface: 192.168.1.67, Subnet Mask: 255.255.255.0.

In order for the computer to communicate with VoIP GSM gateway through HTTP

protocol and users can make configuration on VoIP GSM gateway through a

browser, firstly, it needs to make the following configuration for TCP/IP protocol:

(1) Please make sure your network card of PC, the IP address is same as

192.168.1.x, if not, please add the IP address of the computer and the one

of VoIP GSM gateway into the same segment so that it can access the

configuration interface of VoIP GSM gateway through the browser, i.e., set

up the computer’s IP address as “192.167.1.x”, in which, x can be any

values from 1 to 254 except for 100.

(2) Set up the subnet mask of the computer as 255.255.255.0.

(3) DNS server of the computer points to a valid DNS server or keeps

unchanged. After setting up TCP/IP protocol correctly, access the VoIP

voice gateway by means of command line or Web, and set up the

parameters.

4.2.2 Connect VoIP GSM Gateway through Browser

(1) Open the browser and type http://192.168.1.67 in address bar, the

dialogue box is popped up as follows after “Enter”, If the connection is

correct, the Web Browser will prompt you to enter the “User name” and

“Password” as shown below.