User manual

11
WT-9001 IP65 GSM Remote Control And Alarm System
WT-9001 IP65 – USER MANUAL – Rev. 3.4 – Technical Support: [e-mail]
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD
You can program the WT-9001 via SMS commands using your phone. Any programming
command sent by SMS must be in CAPITAL letters. The fields between square brackets
are parameters; do NOT enter the square brackets. When you send a command, you will
receive the answer for the first time even if your GSM number is not in the administrator
list. This happens because the WT-9001 recognizes any GSM number as administrator
and answers to it.
Attention: Please program the WT-9001 unit systematically begin with programming the
administrator number.
The 20 administrator numbers can be programmed with a text command via SMS.
Text Command:
*TEL[N]#XXXXXXXXXX
N stands for administrator number 1 - 20
XXXXXXXXXX stands for the phone number you want to program as administrator.
Please note that it is possible to program up to a maximum of 16 digits for a phone
number.
Example:
To program phone number 1111222233 as administrator into list number 1, you would
send the following SMS command to the unit.
*TEL1#1111222233
When the WT-9001 received the message, the LCD will display…
WT-9001
After the SMS command has been processed, the message icon will disappear and the
system will shows “OK” indicate the setting has changed.
5. WT-9001 IP65 PROGRAMMING INSTRUCTIONS (via SMS Only)
5.1 Programming the Administrator Number
Message
received