User manual

17|Page
User Manual V2.6 Date: 12/6/2012
Learning Mode for Remote Controls
It is possible to add remote controls for the system to do so you must have additional identical remote
control with you. To program them to the system, you would send the following text command to the
unit
Messages sent *LERN#
The visual screen will light up when this message has been received and you may press any button on the
remote control if it is programmed and you will see the < OK > and will return a confirmation SMS Message
as.
Message received LEARN-OK and the remote control is programmed successfully
Otherwise Message received LEARN-FAIL
Changing the Password
It is possible to change the 6-digits password of the system. To do this you would send the following SMS
message to the system
Message sent *PAWO#654321
The visual screen will light up when this message has been received and if it is in the correct format you will
see a momentary indication that confirms it is correct and you will the < OK > and will return a confirmation
SMS Message as.
Message Received PAWO-OK and the system is now back in factory default and ready to reprogram.
Reset the System
Passwords are requires to access the system and for resetting the system back to factory default and this
may be required if the user wants to relocate the user or has managed to freeze up the system or lost access
to the control f the system.
Therefore as with most electronic systems the factory reset will re-formulate and program the system to
factory default and you can start again.
To do this you would send the following SMS Message to the system
Message sent *REST#123456
The visual screen will light up when this message has been received and if it is in the correct format you will
see a momentary indication that confirms it is correct and you will the < OK > and will return a confirmation
SMS Message as.
Message Received REST-OK and the system is now back in factory default and ready to reprogram.