User manual

7|Page
User Manual V2.6 Date: 12/6/2012
Setting up the Intercom parameters
The system allows you to adjust certain parameters such as ring time, speaker and Microphone settings etc.
of which may be required to customize certain installations due to site conditions.
Adjusting Call time
To adjust the period of time of the outgoing call from the Call Point it is possible to set the ringing call time
from a period of 20 seconds up to a maximum of 99 seconds before the system moves on to calling the next
telephone number
To set the call time to 25 seconds you would send the following SMS Message to the system
Messages sent *TETI#25
The visual screen will light up when this message has been received and if is in the correct format you will
see a momentary indication that confirms it is correct and you will see the < OK > and the system will return
a confirmation SMS Message as
Message received TETI=<25> and the outgoing call will last 25 seconds before moving on to the next
call and if all three numbers do not respond the system will hang up and disconnect from the network.
Factory default is set at 20 seconds
Adjusting the Talk time
It is possible to set the talk time period of a connected call the system will hold for 1 minute up to a
maximum of 30 minutes before the system disconnect the call automatically.
To limit the talk time to only 5 minutes before the system disconnect the call you would send the following
SMS Message to the system
Messages sent *RITI#5
The visual screen will light up when this message has been received and if is in the correct format you will
see a momentary indication that confirms it is correct and you will see the < OK > and the system will return
a confirmation SMS Message as
Message received RITI=<5> and the connected call will last 5 minutes before it disconnected from the
network.
Adjusting Speaker Volume
It is possible to adjust the Output Speaker Volume via SMS Message from a 0 setting up to 6 (Default value:
5) and to set the speaker volume to level 5 you would send the following SMS Message to the system.
Messages sent *SOUD#6
The visual screen will light up when this message has been received and if is in the correct format you will
see a momentary indication that confirms it is correct and you will the < OK > and the system will return a
confirmation SMS Message as
Message received SOUND<6> and the speaker level has been set to level 6