User manual

8|Page
User Manual V2.6 Date: 12/6/2012
Adjusting Speaker Volume
It is possible to adjust the Microphone Volume via SMS Message from a 0 setting up to 9 (Default value: 2)
and to set the Microphone volume setting to level 4 you would send the following SMS Message to the
system.
Message sent *MICO#4
The visual screen will light up when this message has been received and if is in the correct format you will
see a momentary indication that confirms it is correct and you will the < OK > and the system will return a
confirmation SMS Message as
Message received MICO:4 and the Microphone setting is now at level 4
Output Relay Operations
The system has two output relays both factory set as default to latch for one second when operated via the
Intercom mode when being activated via the handset of the person called.
On receiving a call the person called can control both relay one and two using the following keys on their
handset whilst the call is active
.
Press * will activate relay one whilst the call is active!
Press
# will activate relay two whilst the call is active!
Once the person called has been advised the Gates or door has been activated and allowed access they can
just hang up the call to disconnect the call.
Just hang up the call will terminate the call and disconnect the system from the network.
Changing the Default Relay settings
It is possible to change the Default Relay settings for both relay one and relay two to suit the customers
application and this change of settings is the same settings for when the system is called via caller ID to
activate relay one and the setting when the customer activates relay two via their handset whilst an incoming
call is active using the Intercom.
To change the default setting of relay one to 10 seconds from one second you would send the
following SMS Message to the system
Message sent *EXT1#00010 and the command can be used up to a maximum of 65535 seconds with 5
digits from 00001 to 65535
The visual screen will light up when this message has been received and if is in the correct format you will
see a momentary indication that confirms it is correct and you will the < OK > and the system will return a
confirmation SMS Message as
Message received EXT1=00010 and relay one will latch for 10 seconds when called via caller ID or
latched via the customers handset when called using the
* prompt
To change the default setting of relay Two to 360 seconds from one second you would send the
following SMS Message t the system