Owner's Manual

What does it do?
WiZ motion sensor triggers automatic responses to turn on and turn off the lights
according to motion detection . You can also select the mode and brightness of your
choice for "motion" and " no motion" states. For example, you could say "go to
Daylight when there is motion, and night light when there ,s none ". Motion detection
works without Wi-Fi . The detection range is approximately 3 meters (10 feet) with
a beam angle of 120 degree .
The motion sensor control range (i.e the di stance between the motion sensor and
controlled lights) ts approximately 15 m (SO feet) in a normal room environment with
partitions and walls. Range can be longer with a clear line of sight. The exact distance
depends on the surrounding environment as obstacles may weaken the signal.
Ce1 hng Installation
Wall installation
~~ i..----- ....-- ----
~ A
/; I' I\\. :
··,. / . \ ' "'
I I \ \
•• --.-+.~~ l:
O il )M
· ?J
, .. J ~ -- A
... i,,: ~. '· -
\'':-,,..... ...
1\ \' '
.. . --,.-,
••
,.
.,.
,.
.. .
,.
)]ft
..
Oft
,.
)]ft
.,.
-
J11 , . 0• 1•
Hft J Jfl 0 111 Ult
Top view
'
',\'\ /1
~\ . ';/~
' ,, tf/
,.
.. .
-;-;· ~< 1 -
', I . -
,.
...
;',' \ \ ,,
.. 1. // j' \
10ft ;
~ • h ~
,.
...
- )]ft " )]ft
,.
"'
,.
mo
, .
"'
,.
.. .
0• I• h1 )11
Oft llft O ft 10 1
Top view
,l;~ ;)>
I// ,
,,.
0111 .,,,_ , ...
Oft ~ -/ ' . . - I o••
' {'
'·
J;~ ' ~,
,.
.. .
~ ;--.---...---~
0• 1111 2111 l•
Ott U lt Ult lCl lt
Adjust the sensitivity of the sensor a nd the battery usage time
RT: Response Time (the def ault setting) It incr eases the responsiveness of the sensor, which will report the
absence of motion after S minutes .
LT: LI,. Tlme (of battery). It makes the sensor report the absence of motJon after 12 minutes. thus increase
the battery fet,~
a)
(iJ,i ~ =
-- ~
Product
Reference
Location
Ambient temperature
Battery type
2
l~I
3 m
~ 'C::,(l) a)
--~
WiZ PIR motion sensor
9290024248
For indoor use
-2o·c - +45 C / -4 . F - +113 . F
LR6 (AA) 1.5 Vd .c x 2 (not provided)
Impo r tant informat ion
• For indoor use only . Do not try to open or repair it (except battery replacement) .
• Suitable for dry location only .
Use only with specified batteries; do not use rechargeable batteries; do not use
different brand or new / old batteries together; replace the exhausted batteries tn time .
Keep ,t away from water and heat source (e.g heater, air cond1t1oner airflow) .
Symbols explanation
:a
-
0
Waste Electrical and Electronic Equipment
This product must be disposed of at a designated collection point
for Electrical and Electronic waste. For more information, c ontact
your local city off i ce or the shop where you purchased the product.
Indoor use only
Caution:
Thts device compiles with Part 15 of the FCC Rules / Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions : (1) this device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation .
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE :
This equipment has been tested and found to comply with the ltmits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions , may cause harmful
interference to radio communications .
However , there is no guarantee that interference will not occur in a particular
installation. If th is equipment does cause harmful interference to radio or television
reception , which can be determined by turning the equipment off and on , the user ts
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected .
-Consult the dealer or an experienced radio/TV technician for help.
MPE Remindi ng
To satisfy FCC/ IC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during devi ce
operation.
To ensure compliance, operations at closer than thts distance is not recommended .
Wi-F i' , the Wi -Fi logo , the Wi -Fi CERTIFIED logo are registered trademarks of
Wi-F i Alliance.
Wt-Fi CERTIFIED '" , WPA2 '" are trademarks of Wi-Fi Alliance.
Google , Google Play and the Google Play logo are trademarks of Google LLC.
The Apple logo and Siri are trademarks of Apple Inc ., registered in the U.S. and other
countries and regions. App Store is a service mark of Apple Inc.
All product names, logos and brands are property of their respective owners .
Any use of such marks by Signify is under license.