User manual

Getting Started
3
The Pen Power Supply
The Pen comes with 2 AAA Alkaline batteries.
Safety Points (Batteries)
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Use
AAA Alkaline batteries only.
• Always place 2 fresh batteries in the Pen. It is not advisable
to use the Pen with batteries that are not at the same
voltage level.
• Do not combine different types of batteries (e.g.
rechargeable and non-rechargeable).
• Dispose of used batteries according to the manufacturer's
instructions.
Preserving Battery Usage
To optimize battery usage, go to Set Auto Shut-Off Time in Preferences in
the Pen Main Menu and modify the settings according to your needs.
External Power Supply (using the USB cable)
Connecting the Pen to the PC using the USB cable automatically activates
the power supply from the PC. This has the following implications:
• The Pen uses the external power supply when connected to
the PC, so batteries last longer.
Caution: Do not use the Pen without batteries. Unsaved information
may be lost if the USB cable disconnects while using without
batteries.
• Set Auto Shut-Off Time in Preferences is disabled when
the Pen is connected to the PC.
Unpacking the Pen
To get started:
1. Remove the Pen from the protective case.
2. Lift the battery cover on the back of the Pen by pushing the
tab down and out.
3. Insert the batteries into your Pen with the positive and
negative terminals corresponding to the markings on the
sides of the battery compartment. Make sure the batteries
are always inserted when using the Pen, even when
connected to the PC.
4. Close the battery compartment.
5. Remove the protective cover from the Pen tip.
6. Turn the Pen on by pressing the red Power key.
The Pen is ready to scan!