User's Manual

WizFi 210 User Manual (WIZnet Co., Ltd.)
21
AT&K n=0 (disable) =1 (enable)
IF 1, software flow control is enabled.
Ex) AT&K0, AT&K1
AT&R n=0 (disable) =1 (enable)
IF 1, hardware flow control is enabled.
Ex) AT&R0, AT&R1
ATS n=0 to 5; p=(parameter value)
Sets various timeout values;
0 (Network Connection Timeout,
10 milliseconds, 1~65535, default 1000)
1 (Auto Associate Timeout
10 milliseconds, 0~65535, default 500)
2 (TCP Connection Timeout
10 milliseconds, 0~65535, default 500)
3 (Association Retry Count
Not currently supported)
4 (Nagle Algorithm Wait Time
10 milliseconds, 0~65535, default 10)
5 (Scan Time
1 milliseconds, 0~65535, default 20)
Ex) ATS0=1000, ATS1=500
ATI n=0 to 2;
Various Adapter ID information;
0 (OEM identification)
1 (Hardware version)
2 (Software version)
Ex) ATI0, ATI2
Table 15. Uart / adapter interface configuration
(3) Profile management
Command Parameters Responses / Effects
AT&W n=0 (profile 0) =1 (profile 1)
Save profile specified by n.
Ex) AT&W0
ATZ n=0 (profile 0) =1 (profile 1)
Load profile specified by n.
Ex)
ATZ0
AT&Y n=0 (profile 0) =1 (profile 1)
Set default profile to the value n.
AT&Y0
AT&F Restore profile to factory default values.
AT&V
Current and saved profile parameter values as
ASCII.
Table 16. Profile management