User's Manual

WizFi320 User Manual
© Copyright 2021 WIZnet Co., Ltd. All rights reserved. 24
showing the corresponding parameters; if you set them as 0, it means
NOT showing the corresponding parameters.
o bit 0: determine whether <ecn> will be shown.
o bit 1: determine whether <ssid> will be shown.
o bit 2: determine whether <rssi> will be shown.
o bit 3: determine whether <mac> will be shown.
o bit 4: determine whether <channel> will be shown.
o bit 5: determine whether <freq_offset> will be shown.
o bit 6: determine whether <freqcal_val> will be shown.
o bit 7: determine whether <pairwise_cipher> will be shown.
o bit 8: determine whether <group_cipher> will be shown.
o bit 9: determine whether <bgn> will be shown.
o bit 10: determine whether <wps> will be shown.
• [<rssi filter>]: determine whether the result of the
command AT+CWLAP will be filtered according to rssi filter . In other
words, the result of the command will NOT show the APs whose signal
strength is below rssi filter . Unit: dBm. Default: –100. Range: [–
100,40].
• [<authmode mask>]: determine whether APs with the following
authmodes are shown in the result of AT+CWLAP. Default: 0xFF. If you
set bit x to 1, the APs with the corresponding authmode will be shown. If
you set bit x to 0, the APs with the corresponding authmode will NOT be
shown;
o bit 0: determine whether APs with OPEN authmode will be
shown.
o bit 1: determine whether APs with WEP authmode will be shown.
o bit 2: determine whether APs with WPA_PSK authmode will be
shown.
o bit 3: determine whether APs with WPA2_PSK authmode will be
shown.
o bit 4: determine whether APs with WPA_WPA2_PSK authmode will
be shown.
o bit 5: determine whether APs with WPA2_ENTERPRISE authmode
will be shown.
o bit 6: determine whether APs with WPA3_PSK authmode will be
shown.
o bit 7: determine whether AP with WPA2_WPA3_PSK authmode will
be shown.