User's Manual

WizFi320 User Manual
© Copyright 2021 WIZnet Co., Ltd. All rights reserved. 38
• The configuration changes will be saved in the NVS area
if AT+SYSSTORE=1.
• The set command correlates with the commands that set DHCP, such
as AT+CWDHCP.
o If static IP address is enabled, DHCP will be disabled;
o If DHCP is enabled, static IP address will be disabled;
o The last configuration overwrites the previous configuration.
Example
AT+CIPAP="192.168.5.1","192.168.5.1","255.255.255.0"
AT+CWSTARTSMART: Start SmartConfig
Execute Command
Function:
Start SmartConfig of the type ESP-TOUCH+AirKiss.
Command:
AT+CWSTARTSMART
Set Command
Function:
Start SmartConfig of a designated type.
Command:
AT+CWSTARTSMART=<type>[,<auth floor>]
Response:
OK
Parameters
• <type>:
o 1: ESP-TOUCH
o 2: AirKiss
o 3: ESP-TOUCH+AirKiss
• <auth floor>: Wi-Fi authentication mode floor. ESP-AT will not connect to
the AP whose authmode is lower than this floor.
o 0: OPEN (Default)
o 1: WEP