User's Manual

Repeater Installation
2-1
CHAPTER 2
INSTALLATION
2-1 INTRODUCTION
This chapter provides information for the installation, setup and alignment of the R19X0 PCS
Repeater. The information consists of procedures for unpacking, inspection, and preparation for
reshipment or storage, and description of unit connectors. It also provides initial start-up
instructions and installation verification tests.
2-2 UNPACKING AND INSPECTION
Examine the shipping carton for damage before unpacking the unit. If the shipping carton is
damaged, try to have the carrier's agent present when the equipment is unpacked. If carrier's agent is
not available, retain the shipping cartons and padding material for the carrier's inspection if damage
to the equipment is evident after it has been unpacked.
Verify that the equipment is complete, as listed on the packing slip. Contact Watkins-Johnson
Company, Palo Alto, California, or your local Watkins-Johnson representative with details of any
shortage.
The unit was thoroughly inspected and factory adjusted for optimum performance prior to shipment.
Thus, it is ready for use upon receipt. After unpacking and checking contents against the packing
slip, visually inspect all exterior surfaces for dents and scratches. If external damage is visible,
contact Watkins-Johnson Company.
2-3 PREPARATION FOR USE
2-3.1 Power Requirements
The R1910 is equipped with a power supply that accepts 115 / 230 VAC 1.6 / 0.8 Amps @ 60 /
50 Hz single phase. Power consumption of the R1910 is approximately 65 Watts. The R1920/30/40
is equipped with a power supply that accepts 115/230 VAC 4 / 2 Amps @ 50/60 Hz, with optional
+24VDC/Battery input. Power consumption is approximately 250 Watts.
___________
WARNING
Removing or defeating the ground prong on the power cord may
present a lethal shock hazard. Do not use an ac two-to-three wire
adapter plug with this unit.
The R1910 power cord has a 3-conductor grounded plug complying with the National Electric Code
(NEMA Type 5-15P) for 110 VAC operation. For the R1920/30/40, or for operation at other
voltages, contact Watkins-Johnson Company or a qualified service technician.