User's Manual

Repeater Installation
2-2
2-3.2 Software Installation
The repeater control application provided on 3.5” floppy disks or CD-ROM, runs on any Personal
Computer (PC) running Microsoft Windows 95, 98, or NT 4.0 or higher. The computer must also
have one of two serial communications ports available for use, COM 1 or COM 2. To install the
application, insert disk 1 into floppy disk drive A: and from the Start menu select Run and enter
“a:\setup” in the text box of the Run window. Click the OK button and follow the instructions given.
2-3.3 Operating Environment
Environmental conditions during operation should normally be limited as follows:
R1910:
a. Maximum humidity: 95%
b. Temperature range: -10°C to +45°C.
R1920/30/40:
a. Temperature range: -40°C to +50°C.
2-4 PRE-INSTALLATION INFORMATION
2-4.1 R1910
You will need to know some basic information before beginning the R1910 installation. Write this
information down, you will need it later on.
1. Base station location and Channel number to be repeated.
2. Reverse Tracking offset in dB (Optional).
3. Location where the Donor antenna is to be installed.
4. Location where the Server antenna is to be installed.
5. Phone number of modem line. (Optional)
6. Location where the R1910 is to be installed (Lat/Long).
2-4.2 R1920/30/40
You will need to know some basic information before beginning the R1920/30/40 installation. Write
this information down, you will need it later on.
1. Base station location and Channel number to be repeated.
2. Reverse Tracking offset in dB (Optional).
3. Location where the Donor antenna is to be installed.
4. Location where the Server antenna is to be installed.
5 Phone number of modem line.
6. Location where the R1920 is to be installed (Lat/Long).
2-5 INSTALLATION INFORMATION