User's Manual

Repeater Installation
2-5
WJ #
Connects to:
Cable Description
Manufacturer
MFG #
860000-
AC
3 Pin Mini-Change
Brad Harrison
40903
860000-
Battery
6-Pin Mini-Change
Brad Harrison
41621
860000-
Modem
3-Pin Micro-Change
Brad Harrison
703000D02F12
860000-
Remote control
5-Pin Micro-Change
Brad Harrison
705000A13F060
The Modem cable should be wired to the modem line surge protector (refer to section 2-5.6).
Protection to the modem cable should be provided to avoid exposure to lightning and power
conductors in accordance with NEC 725-54c & 800-30.
2-5.6 Required Hardware
1265-21 Joslyn Surgitron II AC line
surge protector
Joslyn Electronic Systems Co.
7040-01-D Joslyn Station Protector
Modem Line Surge Protector
Joslyn Electronic Systems Co.
APT-NFNF-9 Type N F-F RF lightning
protection
Andrew Corporation
Primary protection should be located no further than 12ft away from the unit.
2-5.7 Recommended hardware
Depending on the type of structure the R1920/30/40 will be mounted to, additional hardware may be
required. Listed below is the manufacture name and commonly used hardware for a typical repeater
installation.
Manufacture Part Number Description Manufacture Name
A-1200-S Slotted Channel Thomas & Betts (Superstrut)
CM-100-3/8 Nylon Cone Nut Thomas & Betts (Superstrut)
E-142-3/8x1-1/2 Hex Head Cap Screw Thomas & Betts (Superstrut)
E-145-3/8 Standard Hex Nut Thomas & Betts (Superstrut)
A-210 Bracket Thomas & Betts (Superstrut)
S-218 14” Shelf Thomas & Betts(Superstrut)