User's Manual
Table Of Contents
- Introduction
- Installation and Operation of demonstration Graphical User I
- Minimum System Requirements
- Software Installation
- Starting the Apache server
- Reader Administrator Console (TagHunterTM)
- Find Tags (Button)
- Air Protocol (Radio Button)
- Setting a Configuration (drop down list box)
- Antenna selection (checkboxes)
- Tag Inventory (operation)
- Refresh (Button)
- Manage Tag Memory
- Raw Memory Read Write
- EM_Data
- New config
- Host-Reader Interface
- Troubleshooting / technical support
- Technical specifications
- Notices
- Regulatory Compliance
Using the different fields in this window, a user can specify the staring word address in hex where data
needs to be written into or read from and the length of data (byte count).
To write into memory, specify the file path or browse to look up a particular file and click on save into tag
memory. To read the memory, the read raw memory button needs to be clicked on. The memory dump
section will then display the data in hex character format and equivalent text or ASCII data.
Currently only user memory can be read and written into.
3. EM_Data
This option displays the E-manifest data stored on the tag, if any. The following screen displays this data:
Copyright© 2006 by Intelleflex Corp. Subject to change without notice. This information is provided “as is,” and
Intelleflex makes no claims of fit for purposes intended, merchantability or other. All trademarks, service marks, trade
names and logos are used in good faith and remain the property of their rightful owners.
page 13