User manual

Industrial Cellular Router User Manual
www.wlink-tech.com 12
2.4 How to Install
2.4.1 SIM/UIM card install
If use dual SIM/UIM card router, you may need insert dual SIM before configure it. After
installation, please follow below steps to connect the router.
Before connecting, please disconnect any power resource of router
2.4.2 Ethernet Cable Connection
Use Ethernet cable connect the cellular Router and computer directly, or transfer by a
switch.
2.4.3 Serial Port Connection
If you want to connect the router via serial port to laptop or other devices. To do this you
need a serial port or RJ45 cable, this cable is optional. One end connect to computer
serial port, other end connect the console port on the router
Before connecting, please disconnect any power resource of router
2.4.4 Power Supply
In order to get high reliability, Wlink Series Router adapt wide voltage input: +5V ～
+36VDC, support hot plug and complex application environment.
2.4.5
Review
After insert the SIM/UIM card, connect Ethernet cable, necessary antenna, then connect
power cable.
Please connect the antenna before connect the power cable, otherwise because of
impedance mismatching, the signal maybe poor.
Notice:
Step 1 Check antenna connection.
Step 2 Check SIM/UIM card, confirm SIM/UIM card is available.
Step 3 Power on the industrial Router
----END