User manual

Descaling programme

Your coffee machine has an automatic descaling programme.

Note: Once started, the descaling programme should not be

interrupted. This is for the safety of all users. This is to prevent coffee

from unintentionally being brewed if the descaling solution has not yet

been completely been rinsed out. In an emergency, you can stop the descaling

programme by pressing the Start / Stop button (1). In this case, you should then rinse

out the tank (5) and afterwards ﬁll to the 10-cup mark (version with teapot) or to

the 8-cup mark (version with vacuum jug) with fresh tap water and allow this to

run through the machine.

▪ Insert a paper ﬁlter and place the pot in the machine. Any more substantial

amounts of limescale residue collect on the ﬁlter paper and thus prevent the

spout becoming clogged. Fill the empty water tank with the descaling agent

dosed according to the manufacturer’s instructions for a descaling procedure.

Fill the water tank (5) with cold tap water up to the 10-cup mark (version with

teapot) or up to the 8-cup mark (version with vacuum jug).

▪ To start the descaling, press the button

(3) and the Start/ Stop button (1) will

ﬂash blue. Conﬁrm the start of the descaling programme by pressing the blue

ﬂashing Start / Stop button (1).

The Start / Stop button (1) illuminates blue during the descaling programme.

Note: If you wait longer than approximately 3 seconds to start the descaling

programme, the descaling programme deactivates again and the Led of the Start

/ Stop button (1)

▪ The descaling programme automatically ends after approximately 40 minutes and

the LED of the Start / Stop button (1) turns off.

Note: During the descaling process, the device will switch on and off several

times.

▪ Important: Then to rinse, ﬁll the tank (5) to the 10-cup mark (version with

teapot) or to the 8-cup mark (version with vacuum jug) with fresh tap water

and allow this to run through the machine.