coffee wakes up the world User Manual WMF Cup&Cool WMF Cup Add-on Equipment bistro! 2000S presto! 1400 prestolino! 1300 Model Series 9018 / 9019 Order Nr. 33 0916 1000 Edition 04.
General Information Congratulations on the purchase of your WMF add-on equipment Cup or Cup&Cool. You will be impressed by its technical design and durability. The WMF Cup&Cool is a combination of a cup rack and a cooler. Cups, coffee mugs and coffee pot are heated and stored ready for use in the cup rack. The stainless steel shelves are antifingerprint-coated. The cooler is used for hygienic storage and cooling of milk for preparation of coffee beverages made with milk, such as cappuccino or milky coffee.
Table of Contents Chapter 1 1.1 General Information 20 Designation of parts of the device 20 Chapter 2 2.1 2.2 2.3 Operating Cup rack 21 Switch on the cup rack Fill the cup rack Switch off the cup rack Chapter 3 21 21 21 Operating the cooler 22 3.1 3.2 Switch on cooler Fill the milk container 3.2.1 One milk type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.2.2 Two milk types. . . . . . . . . . . . . . . . . . . . . . . . . . .
General Information Chapter 1 1.
Operation Chapter 2 2.1 Operating Cup rack Switch on the cup rack Plug in the mains plug Switch on the cup rack at the On / off switch at the top left on the rear wall The switch lights up in green. The illumination (optional) is switched on using the switch for the cup rack. The cup rack is heated after about 60 minutes. 2.2 Fill the cup rack Carefully place the desired cups, coffee mugs and coffee pots with their openings downward in the cup rack Please put the cups in carefully.
Operation Chapter 3 3.1 Operating the cooler Switch on cooler If the cooler was not transported in a standing position then it must be given at least 2 hours to stand quietly before switching on. Plug in the mains plug Switch on the cooler at the On / off switch at the top right on the rear wall The switch lights up in green. The cooler is at operating temperature after about 60 minutes. The cooler keeps the milk cool but cannot cool down hot milk. Always use precooled milk. 3.
Operation 3.2.2 Two milk types Only available in the wide version together with the bistro! Open the front door Pull out milk containers Push the lid of the milk container back Pour milk into each milk container Push the lids of the milk containers back Push the milk containers back in carefully Insert the adapters for the milk hoses into the connector on the milk lids Close the front door • Do not kink the milk hoses. • Milk type 1 is always on the right.
Care 3.4 Switch off the cooler Switch off the cooler at the On / off switch at the top right on the rear wall Remove mains plug The switch will no longer be lit up. If this is not observed, the warranty is invalidated in the event of any resultant damage. Observe the manual. Observe the chapter Safety. Clean the inside of the device before longer breaks in operation. Leave the front door open. Chapter 4 Care Do not clean with scouring powders or similar.
Care 4.2 Cleaning the milk container / milk hose The milk container and milk hose must be cleaned every day.
Care 4.4 Defrosting the cooler If the ice layer is more than 3 mm thick, defrost the cooler. For coolers with integrated low-level warnings, any ice buildup on the rear vertical wall should be avoided. This prevents malfunctions. Switch off the cooler at the On / off switch at the top right on the rear wall Leave the front door open Wipe away the water from melting ice with a soft cloth Close the front door before switching on again Never remove the ice layer with sharp or pointed objects.
Safety Despite safety devices, every machine poses numerous hazards if incorrectly used. Please observe the following instructions when using the device so as to prevent injury and health hazards: Burn hazard. The stainless steel shelves become hot. Allow to cool before cleaning. Risk of glass fragments! Please put the cups in carefully. If the cups are not put in carefully the glass side walls may be chipped. Health hazard. The cooler may be used to cool milk only in the containers provided.
Safety • After a break in operation of several weeks we recommend thorough cleaning. • If the cooler was not transported in a standing position then it must be given at least 2 hours to stand in a vertical position before switching on. 5.3 Directives The machine fulfills the requirements of the Regulation on Commodities (and counterparts in the European Plastics Directives) and the EC regulation No. 1935 / 2004 in the currently valid edition.
Warranty The operator shall ensure that electrical equipment and operating facilities are in a fit state (e.g., to BGV A3). In order to ensure operational safety of your device regular inspection is necessary. These measures are conducted by the WMF Service or by WMF authorised service 5.5 personnel as part of the maintenance work. The manufacturer‘s specifications regarding maintenance cycles and frequency of maintenance are to be observed.
Technical Data Chapter 6 6.
Technical Data 6.2 Conditions for usage and installation Necessary preparatory work at the customer‘s premises are to be arranged by the machine operator. The work must be carried out by authorised installation technicians in compliance with general, country-specific and local regulations. The WMF Service engineers may only connect the machine to existing prepared connection points. WMF Service is neither authorized nor responsible for carrying out any work on-site prior to connection.
Malfunctions, Accessories and Spare Parts Chapter 7 Malfunctions Error pattern Action instruction Cooler cabinet iced up • Check: Is the door always closed? • Check: Is the seal OK? • Check: Is the cooling set too low? The mains switch is not lit up • Check: Switch on device? • Check: Is the mains plug plugged in? • Check: Is the local fuse defective? The cooler does not cool See the mains switch is not lit up.