User's Manual
Table Of Contents
- Introduction
- Modules RF band support
- Features
- Module Connection Interface
- Environmental Specifications and Certifications
- Environmental Specifications
- Certifications
- Green Product Compliance
- Pin Definitions
- LGA Module Pin Diagram
- LGA Module Pin Definitions
- Electrical Specifications
- Power supply
- Power consumption
- I/O Interface
- USB interface
- UIM interface
- Control interface
- Power-on/ WAKEUP_IN Signal
- WAKEUP_OUT interface
- Reset Signal
- SPI Master Interface
- PCM Interface
- I2S Interface
- I2C Interface
- UART Interface
- ADC Interface
- RF Specifications
- Band support
- Bandwidth support
- RF Transmit Specification
- RF Receiver Specification
- GNSS Receiver Specification
- Software Interface
- Support tools
- USB interface
- Mechanical
- PCBA Form Factor
- Design Guide
- Power supply
- Thermal design
- USB design
- RF connection
- Interference and sensitivity
- GNSS external circuit design
- Reflow
- PCB pad design
- Stencil
- Antenna design requirement
- Labeling and Packaging
- Labeling
- Packing
- MSL level
- Safety Recommendation
21
/
65
Product Technical Specifications
□ Normal □ Internal Use Confidential □ Restricted Confidential
SPI_EN_1
SPI chip select
DO
I2C_SCL
Clock signal
DO
SPI_CLK
SPI serial clock
DO
SPI_MOSI
SPI master out slave in
DO
NC
NC
-
SPI_MISO
SPI master in slave out
DI
Module Control and State
Interfaces
WWAN_STATE
Wireless WAN Radio
State
DO
POWER_ON
Power On the module
DI
WAKEUP_OUT
Module wakes up host
DO
WAKEUP_IN
Host wakes up module
DI
RESET
Reset the module
DI
Power and Ground
VREF
Voltage Reference
Output
AO
VCC
Main Power
AI
GND
GND
AI
General Purpose
GPIO
Digital I/O
DI/DO
ADC_CONVENTOR
ADC_CONVENTOR
AI
AUDIO- PCM/I2S（RFU）
PCM_DIN
PCM_DIN
DI
I2S_DATA0
I2S_DATA0
DI/DO
PCM_DOUT
PCM_DOUT
DO
I2S_DATA1
I2S_DATA1
DI/DO
PCM_CLK
PCM_CLK
DO
I2S_SCK
I2S_SCK
DO
PCM_SYNC
PCM_SYNC
DO
I2S_WS
I2S_WS
DO
RFU- RFU
RFU
Reserved For Future Use
-
Debug- Force_USB_BOOT
Force_USB_BOOT_CONFIG
Force USB BOOT CONFIG
DI