User's Manual
Table Of Contents
- Introduction
- Modules RF band support
- Features
- Module Connection Interface
- Environmental Specifications and Certifications
- Environmental Specifications
- Certifications
- Green Product Compliance
- Pin Definitions
- LGA Module Pin Diagram
- LGA Module Pin Definitions
- Electrical Specifications
- Power supply
- Power consumption
- I/O Interface
- USB interface
- UIM interface
- Control interface
- Power-on/ WAKEUP_IN Signal
- WAKEUP_OUT interface
- Reset Signal
- SPI Master Interface
- PCM Interface
- I2S Interface
- I2C Interface
- UART Interface
- ADC Interface
- RF Specifications
- Band support
- Bandwidth support
- RF Transmit Specification
- RF Receiver Specification
- GNSS Receiver Specification
- Software Interface
- Support tools
- USB interface
- Mechanical
- PCBA Form Factor
- Design Guide
- Power supply
- Thermal design
- USB design
- RF connection
- Interference and sensitivity
- GNSS external circuit design
- Reflow
- PCB pad design
- Stencil
- Antenna design requirement
- Labeling and Packaging
- Labeling
- Packing
- MSL level
- Safety Recommendation
60
/
65
Product Technical Specifications
□ Normal □ Internal Use Confidential □ Restricted Confidential
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the
antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or
antenna.
As long as 2 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed
IMPORTANT NOTE: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may
be installed such that 20 cm may be maintained between the antenna and users.
The final end product must be labeled in a visible area with the following: “Contains
FCC ID: NKRIMQ3”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.