User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
87
Chap ter 5 Menu List
3G SDI I/ O Confi gu ration Me nu
• Re-Embed: Pressing this encoder toggles between Pass Thru and
Select .
• Pass Thru will cause the 3G SDI card to pass its input
channels directly through to its reclocked output without any
changes and without any SDI Audio Delay .
• Select will let you select any input card sources, and any
Dolby decoder sources (if equipped) to be re-embedded in the
reclocked output. De-embedded pairs that are used as Input
Mix Select sources will be delayed by the SDI Audio
Delay . This may be useful when synchronizing an external
video monitor with the audio signals.
The configuration set in Re-Embed: Select mode is remembered
when you select Re-Embed: Pass Thru mode. When you select
Re-Embed: Pass Thru mode, the control labels that cannot be
adjusted are disabled and turn gray as shown in 5–3 on page 88.
Note:
The SDI Audio Delay you set also applies to the AES
outputs on the 3G/HD/SD-SDI I/O card and these AES
signals when used in the re-embedded output.
Im por ta nt :
Each selected source must be clocked by a 48kHz clock that is locked to
the SDI input signal.
Im por ta nt :
A Dolby bitstream should be treated with special care. No attempt
should be made to adjust the Channel Trim or Pan controls.
Likewise, it should not be mixed with any other signal. But it can be
routed to any channel pair.