User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
100
Chap ter 5 M enu L ist
Clus te r Con figura ti o n Screen
• Auto Mode On/Off: Pressing this control turns the action of the
Conditions and Responses on and off. While this is set to Off , the
individual on/off settings of each line are stored unchanged.
• Select Response: Rotating this control displays one of 32 presets
that can be recalled when the Select Condition is met.
Adding an Auto Mode Hot Key
By setting up an Auto Mode hot key, you can quickly and easily turn
the Automation Menu on or off. Refer to the Hot Key Configuration
Menu 1 Through 8 section of this chapter to do this.
When one of the knobs is assigned as an Auto Mode hot key, the
background color of the knob label will be gold if Auto Mode is on and
gray if Auto Mode is off. Since it works in parallel with the Auto
Mode on/off control in the Automation Menu , each one will be
affected by toggling the other one. It determines whether the
Condition/Response settings in the Automation Menu (if any) will be
active or not.
Cluster Configuration Screen
The Cluster Configuration Screen allows you to define and select
clusters for display on the Main Screen .
Note:
This hot key has no settings: simply setting it as an
Automation Menu (on/off) hot key is enough. Moreover,
it is normally not necessary to set up more than one
Automation Menu hot key.
Configuration Selection
Menu
Main Screen
Menu
Configure
Monitor Mixer
Monitor Mixer
Configuration Menu
Cluster Menu
Set Clusters