User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
110
Chap ter 5 M enu L ist
Ha rdware Conf ig ur ation M enu
• Set for DHCP: Pressing this knob resets all the fields ( IP Address ,
IP Mask , Gateway , and DNS ) to all 0s and sets the monitor so it
will accept a DHCP-assigned IP address from your LAN.
• Adjust: Pressing this knob advances the highlight to the octet to the
right. Rotating this knob increases or decreases the octet number
from 0 to 255.
Hardware Configuration Menu
The menu allows you to select a clock source and set reference levels. It
also provides a link to the Unit Information Menu .
Note:
The text area at the bottom of the screen will help you set a
proper IP Address and IP Mask . At this time, the
Gateway and DNS settings are not used.
Also, the center navigation button will change its text from
Cancel to Save/Exit depending on whether the IP
Address and IP Mask settings are usable.
Note:
Except for the Clock Source , these settings are not stored
or recalled as part of a preset. The Clock Source is saved as
part of each preset.
Configuration Selection
Menu
Main Screen
Menu
Configure
Options Option
Configuration Menu
Hardware
Configuration Menu
Configure
Hardware