User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
123
Chap ter 5 Menu List
Me te r Confi gu ration Menu
• Metadata Select: Rotating this knob selects the type of data you
want to display on this line. (If you select [Empty] a blank line will
result on the Main Screen . This can be used to separate the data
lines so they are easier to read.) The height of the blank line is
controlled by the Font Size control.
Meter Configuration Menu
This menu allows you to configure the appearance of the Main Screen
meter characteristics, including: scale, ballistics, limits, reference levels,
and upper, middle, and lower segment set points, and colors.
Figure 5–24 Meter Configuration Menu
• Scale: Rotating this knob steps through the scales for the level
meters. Seven selections are available as shown in Table 5–1 below.
Six settings are predefined; a seventh setting is user defined.
Meter
Configuration Menu
Configuration Selection
Menu
Main Screen
Menu
Configure Main
Screen Main Screen
Configuration Menu
Configure
Meters
Meter Configuration Menu
Save / ExitHelp Cancel
AES
IEC1
VU
0 dBr
-72 dBr
12
-30 dBr
15
-20 dBr
0 dBr =
0 dBFS
4
Float
Bar
Top
Bottom
Scale
Bal-
listics
Limits
Reference
Upper
Segments
Middle
Segments
Lower
Segments
0
-60
-50
-40
-30
-10
-20
Lower
Scale
-30 dBr
50% FS
Division
Size