User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
150
Chap ter 6 I nput/ Ou tput Modules and Options
Addi ng a R e du nd ant P ower Su pp ly
Adding a Redundant Power Supply
The AMP2-16V Series monitors come with a single 150W power supply
that is sufficient to drive a fully-loaded monitor. However, an
additional power supply (also 150W) is available as an option to
provide for system redundancy. Power supply modules are to be
installed into their specialized slots on the far left and far right of the
back panel. When adding an optional redundant power supply,
remove the blank cover to gain access to the power supply slot.
Precautions
Before unpacking your new power supply, make sure you have a static-
free surface on which to work.
Requirements
• A small Phillips screwdriver
• The redundant power supply option kit (See Option Kits on page
164 for more information.)
Adding the AC Power Supply
To install an additional power supply, follow the instructions below.
1. Remove the power cord.
2. Using a small Phillips screwdriver, remove the blank cover plate
on the rear panel on the far right-hand side.
3. Slide the power supply into the slot from the rear panel, making
sure that the power supply’s connector seats securely into the
connector inside the monitor.
4. Replace the screws that hold the power supply in place.
Note:
It may prove helpful to place the monitor with the rear panel
facing you for this procedure.
Im por ta nt :
Keep the blank cover plate for future use. We recommend taping it to
the side of the monitor; but do not cover the air vent.