User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
160
Chap ter 6 I nput/ Ou tput Modules and Options
Ad di ng/Re mo vi ng Modules
15. Connect the ribbon cable to the system card.
Figure 6–21 Replace Rear Panel
16. Replace the rear panel as shown in Figure 6–21 above.
17. Replace the washers and nuts on the REF connectors.
18. Screw in the rear panel from the bottom of the monitor.
19. Replace the lid and the screws.
Removing a Dolby D/E/DD+ Card
To remove a Dolby D/E/DD+ Card, follow the instructions in reverse
for Adding a Dolby D/E/DD+ Card on page 154 and leave the
standoffs attached to the system control board.
Note:
All presets will be set to a factory default appropriate for the
new arrangement of cards.