User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
5
Chap ter 1 Quick Start
Sett ing Up Your M oni tor f or t he Fir st Ti me
Setting Up Your Monitor for the First
Time
To set up your monitor quickly and efficiently, we recommend that you
set up your initial configuration in the order listed below.
1. Configure the Monitor Mixer : Select the inputs to be monitored.
2. Create channel clusters: Cluster the monitored channel meters to
make them most readable.
3. Arrange the Main Screen : Configure the Main Screen
arrangement.
4. Select the metadata to display on the screen (if you want to display
metadata).
5. Save your setup into a preset.
Press the Menu button on the Main Screen to display the
Configuration Selection Menu .
I. Configure the Monitor Mixer
While the Monitor Mixer Configuration Menu (Figure 1–5)
provides a number of feature adjustments, only a few are needed for
you to get started. (The other feature adjustments are explained later in
this manual in Chapter 5: Menu List on page 83.)
Figure 1–5 Monitor Mixer Configuration Menu
Monitor Mixer Configuration Menu
Save / ExitHelp Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Slot 2 SDI-3G In
Pair 4
Slot 2 SDI-3G In
Pair 5
+0 +0 +0+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters