User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 014 Wo h l e r Te c h n o l o g ies , In c. A l l r ights re se rve d.
22
Chap ter 2 I nst al lation
Re ar P anel Co nn ector s
Rear Panel Connectors
Standard Connectors
The AMP2-16V Series monitor back panel contains all of the connectors
except for the headphone jack as shown in Figure 2–1 on page 23. Note
that, as you are facing the rear panel, the audio module slots are
numbered from right to left.
• Power: The AMP2-16V Series monitors use a standard IEC power
cord for the 100 to 240 VAC power connection. A redundant power
supply is optional. (Refer to Option Kits on page 164 for a complete
list).
• Ethernet: The Ethernet port is used for system software upgrades.
• Serial: This DB-9F connector is used for system software upgrades.
• Genlock Ref Input and Pass-Through (Ref): These BNC
connectors are designed to be used in a daisy-chained series
arrangement from unit to unit. A 75Ω BNC terminator (not
supplied) must be installed in the open Ref connector of the last
unit in the chain. These inputs accept composite video sync sources.