User guide

821116: AMP2 -1 6 V S e r i e s U se r Guide

Chap ter 2 Installation

Rear Pane l Connector s

Figure 2–1 Typical Back Panel Layout

Optional I/O Modules and Rear Panel Connectors

The AMP2-16V Series monitors can include any combination of the

optional I/O modules listed in Table 2–1 below.

Blank Cover Plates

for Unused Slots

Power Connector

Blank Cover Plate for

Optional Redundant

Power Supply

3G/HD/SD-SDI Inputs

AES Outputs

Ethernet Port

Serial Port

Unused: For Possible

Future Use

Slot 5 Slot 4 Slot 3 Slot 2 Slot 1

Re-embedded Output

Genlock Ref Input

and Pass Through

Table 2–1 Available Add-On I/O Modules

I/O Module Name I/O Module Description

3G/HD/SD-SDI-V Card

Two 3G/HD/SD-SDI inputs

8 de-embedded AES pairs outputs

1 selected reclocked or re-embedded output

(Includes automatic frame rate detection)

AES Input Card 16 channel (eight unbalanced AES pairs)

AES Output Card 16 channel (eight unbalanced AES pairs)

Analog I/O Card

8 balanced channels in and 8 balanced channels

out

Analog I/O SPDIF TOSLINK Card

8 balanced channels in, 8 balanced channels out,

and 1 optical SPDIF (TOSLINK) input

AVB Listener Card

Provides capability to listen to two AVB streams

carrying up to 8 audio channels in each stream,

for a total of 16 channels.

Dolby Card D/E/DD+ Card

Provides Dolby bitstream decoding for an AES

pair or de-embedded SDI of your choice

a The Dolby D/E/DD+ Card is a daughter card and does not occupy one of the vacant slots and does

not require its own external connectors.