User guide
821116: AMP2 -1 6 V S e r i e s U se r Guide
© 2 0 14 Wohler Te c h no l o g i e s, Inc. All rights re se r ved..
33
Ch apt er 3 The “How Do I...” Chapter
Frequently As ked Q uestions
channels) of AES or analog outputs are available for this use.
Figure 3–6 Output Configuration Menu
4. Press the
Follow Monitor / Free Mix
knob to select
Follow
Monitor
, as shown in the figure below.
5. The
Select Affect
and
Main Volume Affect
controls should be
set to
Yes
, so that the channels selected on the
Main Screen
will
be heard and the volume control will adjust the surround sound.
6. If needed, rotate the
Output Trim
control to adjust the output of
each channel to match the needs of the external surround sound
system. The
Mixer Channel Select
control is used in conjunction
with the
Output Trim
to select the channel to adjust.
7. To turn off the internal speakers so that only the surround
speakers produce audio, use the
Speaker Mute
control in the
Monitor Mixer Configuration Menu
.
Configuration Selection
Menu
Main Screen
Menu
Audio
Processors
Audio Processor Card Menu
AES Output
Configuration Menu
Analog Output
Configuration Menu
or
Analog -or- AES
Card Configuration
Save / ExitHelp Cancel
Mute
With
Phones
Yes
Analog Output Slot 3 Configuration
Menu
Free Mix
Follow
Monitor
Follow
Monitor
+0 +0 +0+0
L. Front R. Front Center LFE
Yes
Yes
Select
Affect
Main
Volume
Affect
Mixer
Channel
Select
Output
Trim
Output 1 Output 2 Output 3 Output 4